What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
08.06.2025 01:41
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
These devices are installed between the “hot” and “neutral” and protective ground.
a photo is worth a thousand words.
One is “what exactly is in a ‘surge protector’ ? ”
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
The Best Tea for Lowering High Blood Pressure, Recommended by a Dietitian - EatingWell
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Nuclear rocket engine for Moon and Mars - European Space Agency
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
but this device (an Inductor) … impedes the rapid changes in the current.
First Sentence:
2024–10–16 [ OO OLAOYE OYEBODE ]
For this case there are devices called Metal oxide varistors (MOV).
This is where this question deviates from being a 'generic' question, and becomes more specific.
What are some disadvantages of living in rural areas? What are the advantages?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
(Dc diagram shown, AC is similar).
Edit 2024–10.
What does a fuse do?
A fuse is a non-resetable over current circuit protector.
But… the neutral is now “floating” because of the 1 ohm resistance.
Are miracles real or do they just have natural explanations?
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
A circuit breaker is similar, but is resettable.
It also is a device that limits the change in current flow.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
This one hit behind the barn.
These are simplified answers to the original question, and does not change anything I wrote above.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Upvotes:
He then describes Rainy Season and Lightning.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
but I think this circuit , shows a few more pieces.
the problem then depends on "how fast does the fuse operate?".
At least they know the answer if they wanted it.
The third is lightning and “how it gets conducted into a home.”
Would Donald Trump's reelection make the world more dangerous?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
[old diagram got deleted by accident]
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
so, what happens?
He then asserts :
This is where the MOV conducts again, and dissipated the energy.
nine
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
What is lightning?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This device then solves the entire problem.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Now when you have a certain ac resistance, then a current flows in a loop.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Here is a simplified AC power diagram.
Because the load is inductive, the current lags the voltage.(by a bit).
It seems Mohan does not understand the difference between a comment and an Answer.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–10–10[John johnson John Johnson ]
But it can get overloaded, and no longer works.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
An AC voltage/ current source, and an ac inductive load.
He then describes the function of a fuse.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–14 [Omar Gharbi Omar Gharbi ]
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
In schematic diagrams this is the symbol for a fuse:
At one ohm, the resistor has a maximum of 1 watt power.
There are two important concepts here.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Barnstars:
I post the exact comment here.
One
what exactly is a ‘surge’ protector?
The bolt then partially travels down the line to your home.
The MOV will conduct when the voltage exceeds 50% of line voltage.
This is 'the assistant's answer'
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
The other is “what does a “fuse” do?”
[image of Common-mode choke]
There are three different concepts here that are getting confused.
eight
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”